DD Platform EuroV Operators Manual chemically cleaned with Detroit™ Genuine Coolant Twin Pack cooling system cleaner/conditioner (or equivalent sulfamic acid/sodium carbonate cleaner) and flushed. Phosphate Inhibitors: Phosphate has tendency to form deposits on surfaces transferring high heat which ultimately affect cooling capabilities. Phosphate deposits on water pump seals will result in coolant leakage across seal faces. Maintenance Topping Off Coolant The coolant level should be checked daily and at each service interval. If topping off is necessary, add coolant which is identical to the initial–fill coolant.
ELCs should be topped-off with a coolant of the same formulation; SLCs should also be topped-off with a coolant of the same formulation. The following tables contain the coolant maintenance intervals. Coolant Maintenance Intervals Extended Life Coolant Additive Maintenance Procedures The concentration of ELC corrosion inhibitors will gradually deplete, at a much slower rate than SLC corrosion inhibitors, during normal engine operation. Corrosion inhibitor limits are established by the coolant manufacturer. Therefore Detroit™ recommends following the manufacturer’s recommendations as to minimum and maximum limits.
Freeze Point Check To best measure the quality of anti-freeze coolant, a check of the freeze point (glycol concentration), by refractometer, should be performed at each service interval to ensure anti-freeze levels are within specification. Detroit™ requires a freeze point of -34°F (+/-10°F) to guarantee optimal engine protection. The exception would be certain regions that require a freeze point of -60°F to protect against colder climates. Laboratory Testing Laboratory testing is the best practice for determining ELC coolant quality and will provide vital information regarding the engine performance.
A factory coolant analysis program is available through authorized Detroit™ service outlets. To verify coolant acceptability, submit a sample for coolant analysis according to Table "Extended Life Coolant". However, a laboratory meeting ISO 17025 requirements may be used in place of the Detroit™ Genuine Parts Program laboratory. All information subject to change without notice. 111 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION