MAN — Temporary Storage (30 Days or Less)

DD Platform EuroV Operators Manual Engine Storage When an engine is to be stored or removed from operation for a period of time, special precautions should be taken to protect the interior and exterior of the engine, transmission and other parts from rust accumulation and corrosion. The parts requiring attention and the recommended preparations are given below. Preparing Engine for Storage It will be necessary to remove all rust or corrosion completely from any exposed part before applying rust preventive compound. Therefore, it is recommended that the engine be processed for storage as soon as possible after removal from operation.

The engine should be stored in a building that is dry and can be heated during the winter months. Moisture-absorbing chemicals are available commercially for use when excessive dampness prevails in the storage area. Temporary Storage (30 Days or Less) An engine prepared in this manner can be returned to service in a short time by removing the seals at the engine openings and by checking the engine coolant, fuel oil, lubricating oil and transmission oil levels. To protect the engine for a temporary period of time (30 days or less), follow this procedure: 1. With the engine at ambient temperature and cool to the touch, drain engine crankcase oil into a suitable container.

Dispose of the oil in an environmentally friendly manner, according to state and/or federal recommendations. 2. Fill the crankcase to the proper level with the recommended viscosity and grade of oil. 3. Fill the fuel tank with the recommended grade of fuel oil. Operate the engine for two (2) minutes at 1200 rpm and no load. Do not drain the fuel system or the crankcase after this run. 4. Check the air cleaner and service it, if necessary. NOTE: If an antifreeze solution is not required during storage, flush the cooling system with a good soluble oil (3% – 5% by volume) rust inhibitor to prevent rusting of the outside diameter of the cylinder liners. 5.

If freezing weather is expected during the storage period, check the antifreeze/coolant for required freeze and inhibitor protection. Add antifreeze solution to the cooling system in accordance with Detroit's recommendations. Refer to section "Coolant Selections and Maintenance" All information subject to change without notice. 121 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION