DD Platform EuroV Operators Manual 5. Install new lubricating oil filters. Fill the crankcase to the proper level with Tectyl® 930A preservative lubricating oil or an equivalent 30-weight preservative lubricating oil meeting Mil-L-21260C, Grade 2 Specification. NOTE: If engines are stored where condensation of water in the fuel tank may be a problem, additives containing methyl carbitol or butyl cellusolve may be added to the fuel. Follow manufacturer's instructions for treatment. Where biological contamination of fuel may be a problem, add a biocide such as Biobor® JF (or equivalent) to the fuel.
When using a biocide, follow the manufacturer's concentration recommendations and observe all cautions and warnings. 6. Drain the fuel tank. Refill with enough clean No. 1 diesel fuel to permit the engine to operate for about ten (10) minutes. If draining the fuel tank is not convenient, use a separate, portable supply of recommended fuel. 7. Drain the fuel system and remove the fuel filters. Dispose of used filters in an environmentally responsible manner, according to state and/or federal recommendations. Fill the new filters with No. 1 diesel fuel or pure kerosene and install on the engine. 8. Operate the engine for five (5) minutes to circulate the clean fuel throughout the engine.
Be sure the engine fuel system is full. 9. Stop the engine and allow to cool. Then disconnect the fuel return line and the inlet line at the primary filter and securely plug both to retain the fuel in the engine. 10. Transmission: Follow the manufacturer's recommendations for prolonged storage. 11. Power Take-Off: If equipped, follow manufacturer's recommendations for prolonged storage. NOTE:
Failure to properly seal off the turbocharger air inlet and exhaust outlet openings before engine storage may permit air drafts to circulate through the turbocharger and rotate the turbine/compressor shaft without an adequate flow of lubricating oil to the center housing bearings resulting in severe bearing damage. 12. Turbocharger: Since turbocharger bearings are pressure lubricated through the external oil line leading from the oil filter adaptor while the engine is operating, no further attention is required. However, the turbocharger air inlet and turbine exhaust outlet connection should be sealed off with moisture-resistant tape. NOTE:
Do not apply oil, grease or any wax-base compound to the flywheel. The cast iron will absorb these substances, which can sweat out during operation and cause the clutch to slip. All information subject to change without notice. 123 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION