MAN — Cruise Control

DD Platform EuroV Operators Manual Engine speed and power are varied under Cruise Control to maintain the set vehicle speed. The vehicle speed must be above Min Cruise Set Speed and below Max Cruise Set Speed. It is recommended that Max Cruise Set Speed be set to the default to allow proper operation of other features such as Fuel Economy Incentive and PasSmart. The Vehicle Speed Limit should be used to limit vehicle throttle speed. Turn the switch ON to energize the system. Remember as a check after each engine start, DDEC looks for a one-time activation of the clutch (if equipped) and service brake before DDEC allows Cruise Control to be enabled.

DDEC must also see or recognize that the Cruise Enable Switch has changed. If the Cruise Enable Switch is OFF it needs to be turned ON. If the Cruise Enable Switch is left in the ON position at key OFF, the switch must be cycled OFF then ON for DDEC to see a status change to allow Cruise Control activation. The status of DDEC inputs to activate Cruise Control at key ON is listed in the following table. Table 2. All information subject to change without notice.

49 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION Input Status to Activate Cruise Control Input Input Status at Key ON Input Status Before Cruise Control Activates Service Brake Switch ON OFF Clutch Release Switch (Manual Trans. only) ON OFF Cruise Control Enable Switch OFF ON