MAN — DD Platform Shifting

DD Platform EuroV Operators Manual With the engine at normal idle, transmission in neutral and service brakes on, press the SPD CNTL Switch, and use the RSM/ACC Switch. The engine rpm should increase to a pre-defined speed. The engine rpm can be raised or lowered from this point using the SET/CST and RSM/ACC switches. Engine Brake and Cruise Control Your engine is equipped with both Cruise Control and an engine brake; the engine brake can operate automatically while you are in Cruise Control. If the Cruise Control/Engine Brake function is turned ON in the DDEC system programming, the engine brake will come on low when your set road speed increases a few mph (kph) above your cruise set speed.

If your speed continues to increase, the DDEC system will increase the engine brake's braking power progressively. When the vehicle returns to the set cruise speed the engine brake will turn off until you need them. For safety reasons, don't use Cruise Control when it is not possible to keep the vehicle at constant speed due to: Winding roads Heavy traffic Slippery pavement Descending grades calling for engine brake assistance For an explanation of the engine brake system and recommendations for proper operation, "Engine Brake System" in this manual. DD Platform Shifting Depending on your transmission model, the gear split may vary from 400 to 500 rpm.

The electronic governor provides almost no overrun capability; and, if the transmission is downshifted too early, you will experience a temporary loss of pulling power until the engine speed falls below rated speed. In general, when using a 7- or 9-speed transmission, you should always downshift between 1150 and 1250 rpm for the DD13 and between 1000 and 1100 rpm for the DD15 and DD16. This is true even on steep grades with heavy loads. When using an 18-, 15-, or 13-speed transmission, you will need to downshift at an rpm that allows "less than rated" rpm before throttle application in the next gear down. You may want to limit engine speed to 1900 rpm in all gears.

DD Platform engines provide horsepower through 2100 rpm, but fuel economy is not as efficient above 1800 rpm. If you decide to drive at a lower rpm for improved fuel economy, don’t let different engine noises throw you off guard. The engine sounds quiet at 1400 rpm, almost as if it had quit pulling. Depending on the air intake arrangement, you may also experience a "chuffing" sound as the engine starts to pull hard at lower rpm. This is All information subject to change without notice. 51 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION