DD Platform EuroV Operators Manual Engine Brake System The engine is equipped with an engine brake. Before operating the vehicle, you must familiarize yourself with the engine brake system to obtain optimum benefit from it. Engine brake control systems may vary slightly, depending on the engine brake configuration and cab design. However, basic operator controls are similar for all models. Driver Control Switches Vehicles with manual transmissions allow the driver to turn the engine brake on and off and select a Low, Medium, or High level of braking. The "Low" setting on this switch activates braking on two cylinders, yielding about one-third engine braking horsepower.
The "Medium" setting on this switch activates four cylinders, supplying about two-thirds engine braking horsepower. The "High" setting on this switch activates all six cylinders, providing full engine brake horsepower. NOTE: There is very little difference in the exhaust sound when the engine brakes are activated in either the medium or high position. Clutch Pedal and Throttle Position Controls Engine brakes have two additional controls, one activated by the position of the clutch pedal and the other activated by the position of the throttle. These controls permit fully automatic operation of the engine braking system.
Engine Brake Activation Conditions The engine braking system only permits fully automatic operation when the following conditions are met: Engine Brake switch is on. An Engine Brake level (Low/Med/High) is selected. Vehicle meets the programmed minimum speed. The Clutch Pedal is out. The Accelerator Pedal is at zero percent activation. All information subject to change without notice. 53 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION