MAN — Operating on Wet or Slippery Pavement

Engine Brake System CAUTION: BRAKE FADE To avoid injury, do not over apply the vehicle service brakes when descending a long, steep grade. Excessive use of the vehicle brakes will cause them to heat up, reducing their stopping ability. This condition, referred to as “brake fade”, may result in loss of braking, which could lead to personal injury or vehicle/property damage or both. 2. Ensure the progressive braking switch is in the appropriate power position (LOW/MED/HIGH). WARNING: PERSONAL INJURY Failure to keep the vehicle within safe control speed limits while descending a grade may result in loss of vehicle control, which could cause personal injury. 3.

Do not exceed the safe control speed of your vehicle. Example: You could descend a 6% grade, under control only at 10 mph (16 kph) without an engine brake, but at 25 mph (40 kph) with an engine brake. You could not descend that same hill at 50 mph (80 kph) and still expect to remain under control. Get to know how much slowing power your engine brake can provide. So get to know your engine brake system before climbing hills and do not exceed a safe control speed. 4. Check your progressive braking switch often for proper position (LOW/MED/HIGH), since road conditions can change quickly. Never skip a step when operating the progressive braking switch.

Always go from OFF to LOW and then to a higher position when on slippery roads. Operating on Wet or Slippery Pavement NOTE: Experience with the engine brake system on dry pavement is recommended before attempting to use it on wet or slippery roads. Operate the engine brake system as follows: 1. On wet or slippery pavement, start with the master switch in the OFF position and use the gear you would normally use under these conditions. 56 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209