MAN — Preventive Maintenance Intervals

Preventive Maintenance Intervals 1. Inspect the radiator, condenser, coolant pump, engine oil cooler, freeze plugs, and heat exchanger for damage and leaks. 2. Check all cooling system pipes and hoses for damage and leaks; ensure they are positioned to avoid chafing, and are securely fastened. 3. Check the outside of the radiator and condenser for blockage. Check fins for damage; straighten them if necessary. Valve Lash Checking and Adjustment Valve lash checking and adjustment should be performed per the maintenance intervals prescribed under the proper service category for the engine.

All three service categories (Severe, Short Haul, and Long Haul) require a 'first time' valve lash adjustment at a shorter interval. After the initial adjustment, all others are based on the same mileage intervals. Proper valve lash clearance allows the engine to produce the best possible performance with the lowest emissions. Valve lash adjustments should be performed by an authorized Detroit™ maintenance or repair facility. Belts should be neither too tight nor too loose. Belts that are too tight impose extra loads on the crankshaft, fan and/or alternator bearings, shortening both belt and bearing life. Excessively overtightened belts can result in crankshaft breakage.

A loose belt will slip and generate excessive heat that may cause damage to the belt and accessory drive components. Drive Belt WARNING: PERSONAL INJURY To avoid injury from rotating belts and fans, do not remove and discard safety guards. Belt Replacement - Refer to the maintenance tables for when drive belts should be inspected and replaced. After an extended time in service, minor rib cracks may appear, usually one or two cracks per inch is considered normal. A concern occurs when the belt ribs exhibit severe multiple cracking or 'chunking'. At this point, the belt should be replaced. 70 All information subject to change without notice.

Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209