DD Platform EuroV Operators Manual 3. Check for oil leaks after starting the engine. Monitoring the Cooling System The cooling system must be full for proper operation of the engine. WARNING: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Check the coolant level daily and maintain it between the full and low marks on the surge tank. 2. Add coolant as required, but do not overfill.
Before adding coolant, Refer to section "Coolant Selections and Maintenance" for the listing of required intervals using the recommended coolants. Checking for Coolant Leaks Perform daily visual checks for cooling system leaks. Look for an accumulation of coolant when the engine is running and when it is stopped. NOTE: Coolant leaks may be more apparent on a engine when it is cold. WARNING: PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked.
Coolant Inhibitors The inhibitors in antifreeze solutions must be replenished with an approved corrosion inhibitor supplement when indicated by testing the coolant. Refer to section "Coolant Selections and Maintenance" for the listing of required intervals using the recommended coolants for required test intervals, inhibitor levels, and approved inhibitors. NOTICE: Coolant must be inhibited with the recommended Supplemental Coolant Additives listed in this manual. Failure to check and maintain Supplemental Coolant Additive levels at required concentrations will result in severe damage (corrosion) to the engine cooling system and related components.
The cooling system is protected by a Supplemental Coolant Additive element. All information subject to change without notice. 79 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION