Yamaha Motor Co., Ltd. VK540E — Yamaha Motor Co., Ltd. VK540E User Manual

10. Remove: Bleed bolt 1 Gasket (bleed bolt) 11. Drain the oil until no more air bubbles ap- pear from the bleed hole. 12. Inspect: Gasket 1 (bleed bolt) Damage/wear Replace. 13. Install: Gasket 1 (bleed bolt) Bleed bolt 2 14. Install: Carburetors Refer to “CARBURETORS” in CHAPTER 6. ESS00036 Cable adjustment NOTE: Before adjusting the oil pump cable, the throttle cable distance should be adjusted. Adjustment steps: Pull back the adjuster cover. Loosen the locknut 1 . Turn the adjuster 2 in or out until the specified distance is obtained. Turning in Length a is increased. Turning out Length a is decreased. Tighten the locknut 1 and push in the ad- juster cover.

2-5 OIL PUMP INSP ADJ Oil pump cable adjusting length a : 24  26 mm (0.9  1.0 in)