Yamaha Motor Co., Ltd. VK540E — Yamaha Motor Co., Ltd. VK540E User Manual

ESS00069 TRACK TENSION ADJUSTMENT WARNING A broken track or track fittings, and debris thrown by the track could be dangerous to an operator or bystanders. Observe the fol- lowing precautions. Do not allow anyone to stand behind the machine when the engine is running. When the rear of the machine is raised to allow the track to spin, a suitable stand must be used to support the rear of the ma- chine. Never allow anyone to hold the rear of the machine off the ground to allow the track to spin. Never allow anyone near a rotating track. Inspect the condition of the track frequent- ly. Replace the track if it is damaged to a level where the fabric reinforcement material is visible.

Never install studs (cleats) closer than 76 mm (3 in) to the edge of the track. 1. Place the machine with the right side facing down. CAUTION: If the machine is left on its left side for more than 80 minutes, the fuel may leak out from the fuel breather hose. 2. Measure: Track deflection a Using a spring scale 1 , pull down on the center of the track with 10 kg (22 lb) of force. Out of specification Adjust. 3. Adjust: Track deflection Adjustment steps: Place the machine onto a suitable stand to raise the track off of the ground. Loosen the rear axle nut 1 . It is not necessary to remove the cotter pin 2 . NOTE: 2-21 TRACK TENSION ADJUSTMENT INSP ADJ Track deflection a :

35  45 mm (1.4  1.8 in)