Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Checks Before Starting is monitor, it indicates that water is accumulated in transparent cap (2). In this case also, use the procedure above to drain the water. 3 - 113 Always check the items in t his section before starting the engin Drain Water And Sediment f rom Fuel Tank ht of the machine. 1. Open the door at the rig 2. Set a container under d 3. Turn drain valve (2) to th sediment and water acc the fuel. 4. When clean fuel comes (S) position. 5. Close the door.

rain hose (1) to catch the drained fu e OPEN (O) position and drain all t umulated at the bottom together w out, turn drain valve (2) to the CLO Check for Water and Sediment in Water Separator, Drain Water 1. Open the pump room d The water separator 2. It is possible to judge th by looking through trans sediment collected at th drain water under drain 3. Loosen drain valve (4) a 4. When fuel starts to dra valve (4) immediately. oor on the right side of the machine forms one unit with fuel pre-filter (1) e water level and amount of sedim parent cap (2). If there is any water e bottom, set a container to catch t hose (3). nd drain the water.

in from drain hose (3), tighten dr On this machine, a sens or is installed to detect if water cap (2). onitor (5) lights up red on the machi accumulated in transparent When the water separator m REMARK When only the water separa tor monitor lights up, it lights up in t position shown in the diagra m on the right. If other monitors also light u p the same time, the water separa monitor lights up at a differe nt position. NOTICE transparent cap (2) freezes, the water separator monitor may not light up. After the engine is If the water accumulated in started, as the temperature a suddenly light up.

In cold a round fuel pre-filter (1) increases, the fr ozen water will melt and the wat er separator monitor may reas, even if the water separator monito r does not light up, drain the wa ter frequently. If the water inside transparen t cap (2) freezes, check that the frozen w ater has melted completely, then use the procedure above to drain the water.