Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Coolant Level, Add Coolant WARNING SYSTEM (PAGE 4-25)". 3 - 116 Do not open th e radiator cap unles s necessary. W hen checking the coolant, alway s wait f or the engine to c ool down and check the sub tank. Immediately a fter the engine is sto pped, the coola nt is at a high te mperature and t he radiator is under hig h internal pressure. If the cap is re moved to check the coolant level in this condition, there is a haza rd of b urns. Wait for th e temperature to go down, then tur n the cap slowly to release the pres sure and remov 1.

Open the d oor at the rear left of the machin e, and check i f the coolant in s ub-tank (1) (show n in the diagr am on the righ t) is between th e FULL and LOW marks. If the c oolant level is low, add coolant to the FULL level through the fil ler port of sub-tank (1). g coolant, tighten the cap securely. tank (1) is empty, there is probably leakage of er inspecting, repair any problem immediately. If problem, check the coolant level in the radiator. If 2. After addin g coolant, tighten the cap secur 3. If the sub- tank (1) is empty , there is pr air any probl coolant. Aft er inspecting, rep em immediate ly. If or.

If there is no problem, check th e coolant lev el in the radiat the coolant level is low, add c oolant to the r adiator, then fil l the sub-tank (1 4. If the inside of sub-tank (1) is dirty and the water level ca nnot be seen, us e the procedure in "CLEAN INS IDE OF COOLING