. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Checking Adjustment (4) with the mounting position of bolt (2) as the fulcrum. 2. Loosen bolt (1) and bolts (2), then move compressor (3) to adjust. 3. When the position of the compressor is determined, tighten bolts (1) and (2) to hold it in position. NOTICE 4 - 51 Press the belt with a finger force of a pprox. 60 N (6. 2 kgf) at a point midway between drive pulley (1) and compres Deflection (A) shou ld be 6.3 to 8.7 mm (0.248 to 0 1.
Loosen bolts (1 Compressor (3) is installed to bracket (4), so when bolts (1) oosened, it becomes possible t Check each pulley for damage, wear o f the V-groove, a nd wear of the V-belt. In particular, be sure to check that the V-belt i s no touching the botto m of the V-groove. In case any of the following occurs, a sk the Komatsu distributor in your territory to replace the be • The fan belt has elongated, leaving little allowance • A cut or crack is found on the belt. • Slipping or crea king sound is hear d coming from th When the new V-b elt is set, readjust i t after one hour