Komatsu — REPLACE FUEL PRE-FILTER CARTRIDGE

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING Prepare a container to catch drain fuel. Prepare a filter wrench 1. Turn the valve (1) at the bottom of the fuel tank to the CLOSE position (S). 2. Open the cover on the right side of the machine. 3. Set the container to catch the fuel under the pre-filter cartridge. 4. Loosen drain valve (2), then drain all the water and sediment in the transparent cap (3) and also the fuel accumulated in filter cartridge (4). 5. Remove connector (5). Wrap the removed connector in a vinyl bag to prevent water from getting on it. 6. Using a filter wrench, turn transparent cap (3) to the left to remove it.

(This cap is used again.) 7. Using a filter wrench, turn cartridge (4) to the left to remove it. 8. Install transparent cap (3) to the bottom of the new filter cartridge. (When doing this, always replace O-ring (6).) 9. When installing, apply oil to the packing surface and bring the packing surface into contact with the seal surface of filter cartridge (4) and then tighten it further by 1/4 - 1/2 turns. If the transparent cap is tightened too much, the O-ring will be damaged and this will cause leakage of fuel; if it is not tightened enough, fuel will leak through the gap at the O-ring. To prevent these problems, always tighten securely to the fixed tightening angle.

4 - 55 After the engine has been operated, all parts are at high temperature, so do no to cool down before starting the operation. High pressure is generated inside the engine fuel piping system when the en When replacing the filter, wait for at least 30 seconds after stopping the en replacing the filter. Do not bring any fire or flame close. NOTICE Genuine Komatsu fuel filter cartridges use a special filter that has highly ef cartridge, always use a genuine Komatsu part. The common rail fuel injection system used on this machine consists of mo pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt system. Always avoid using substitute parts.

When carrying out inspection or maintenance of the fuel system, pay more a stuck to any part, use fuel to wash it off completely.