. MAINTENANCE MAINTENANCE PROCEDURE 10. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. water get on the completely before 14. Turn the valve (1) at the bottom of the fuel tank to the OPEN position (O). 15. After completing the replacement of filter cartridge (4), bleed the air. 4 - 56 NOTICE When adding fuel, do not remove cap (B). Always small holes (A) on the dirty side. After adding fuel, remove cap (B) and install the fu Always fill with clean fuel. Be careful not to let any the fuel. In particular, center portion is the clean sid cap (B) when adding fuel.
Be careful not to let dirt or portion on the clean side. 11. When installing, tighten until the packing sur face contacts the seal surface of the filter holder, then ti ghten it 3/4 of a turn. If the filter cartridge is tightened too far, the filter cartridge is too loose, fuel will also leak When tightening with a filter wrench, be e packing will be damaged and this will lead to leakage of fuel. I f the from the packing, so always tighten the correct amoun 12. Check that the drain valve (2) is tightened s 13.
Remove the vinyl bag covering connector (5 REMARK If water gets on the connector (5), the senso and the water separator monitor may light up connector (5), be extremely careful not to le connector. If water gets on connector (5), dry it c connecting it. Bleed the air as follows: ere the float is at the highest position). 16. Fill the fuel tank with fuel (to the position wh 17. Loosen the knob of feed pump (7), pull it ou t, then pump it in and out until the movement becomes heavy REMARK top of the fuel pre-filter and fuel main filter. It is not necessary to remove the plug at the After the engine runs out of fuel, use the sam e procedure to operate feed pump (7) and bleed the ai 18.
After finishing to bleed air, push in the knob of feed pump (7) and tighten it. ngine and run it at low idling for 10 minutes. 19. After replacing the filter cartridge, start the e Check for leakage of oil from the filter seal s tightening of the filter cartridge. If there is still oil leakage, repeat Steps 1 - foreign material in the packing surface is fou it. urface and tranparent cap mounting. If any oil is leaking , chec k the 7 to remove the filter cartridge, and if any damage or embedded embedded nd, replace it with a new cartridge and repeat Steps 8 - 1 9 to in stall