Komatsu — REPLACE HYDRAULIC OIL FILTER ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE EVERY 1000 HOURS MAINTENANCE Carry out the EVERY 100 HOURS MAINTENANCE, EVERY 250 HOURS MAINTENANCE, and EVERY 500 HOURS MAINTENANCE at the same time. REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING and may cause burns. Wait for the 4 - 66 The parts and oil are at high t temperature to go down before When removing the oil filler cap , turn it slowly to release the internal pressure, the NOTICE hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket f the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorat e much faster than du operations. For details, see "M maintenance.

AINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out 1. Set the work equipment o n the hard and flat ground in the maintenanceposture as sh ground and stop the engine own in the figure, then lower it to the . 2. Remove the cap from oil pressure. 3. Loosen 6 bolts, then remo filler (F), and release the internal ve cover (1). When doing this, the e force of spring (2), so hold the the bolts. valve (3) and strainer (4), take out cover may fly out under th cover down when removing 4. After removing spring (2), element (5). Inspect the bottom of the any. Take good care th hydraulic tank. filter case for dirt, and remove it, if en not to let fall the dirt into the flushing oil.

5. Clean the removed parts in 6. Install the new element in th e place where old element (5) was installed. 7. Set valve (3), strainer (4) a nd spring (2) on top of the element. 8. Set cover (1) in position, pu sh it down by hand, and install the cover with the mounting bo lts. d install the cover. engine according to "STARTING 9. Screw in the oil filler cap an 10. To bleed the air, start the ENGINE (PAGE 3-128)" a minutes. 11. Stop the engine. nd run the engine at low idle for 10