. MAINTENANCE MAINTENANCE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 65 The parts and oil ar e at high temperature imme diately after t he e ngine is stopped, an d may cause s erious burns. Wait fo r the temperature to go d own before starting the op If there is still press ure remaining inside the ca se, the oil or p lug may fl y out. L oosen the plug slowl y to release the pressure. Please do not stand in front of the plug when you loosen the plu Prepare a handle . ark at the top, with the UP mark and plug (P) the ground surface. 1. Set the TOP m perpendicular to 2. Remove plug (F ) using the handle.
Whe n the oil leve l reaches a point 10 mm ( 0.4 in) below the bottom of the plug hole, the F), operate the trave hol correct amount of oil has been added. 3. If the oil level i s too low, install plug ( e forward or in reverse rave levers, and driv to rotate the sprocket gain. sprocket one turn. Then r epeat Step 2 to check a 4. If the oil level is low, add oil through the hole of plug (F). Add oil until oil overf lows from the hole of plu g (F). 9.8 Nm (7 ± 1 kgm, .2 lbft) 5. After checking, REMARK There are two plugs (F). Add oil through the o ne easier to fill o il and through which no in ternal gears are to be se en.