Komatsu — CHECK NITROGEN GAS CHARGE PRESSURE IN ACCUMULATOR (FOR BREAKER)

. MAINTENANCE MAINTENANCE PROCEDURE CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS WARNING Parts and oil are at high temperature immediately after the engine is stopped cause serious burns. Wait for the oil belt. Contact your Komatsu distributors for 4 - 71 Please ask yo ur Komatsu d istributo r to c heck the tight ening of the clamps between the air cleane r - turbocharger - a ftercooler - REPLACE CORROSION RESISTOR CARTRIDG (Machines eq uipped with c orrosion resist and may temperature to go down before performing thi . Screw in valve (1) at th e top of t he co rrosion resist or. . Using a fil ter wrench, tu rn cartridge ( 2) to the left to remove it. .

Install a n ew filter cartri dge after coati ng oil on its s ealing face. In the inst after the face of th A genuine allation, turn the cartridge by two-thirds of one turn packing surfa ce come e cartridge sta Komatsu filte r cartridge is recommende . Open valv . Run the e from the s eal surface. CHECK FAN BELT TENSION AND REPLACE FA N BELT Special tools are required f or inspection and replacement of the t. fan inspection an d replacemen REMARK An installed a uto fan belt ten sion adjuster , "Auto Tensio nal Fan Belt", dispenses with the belt deflect ion adjustment.

CHECK NITROGEN GAS CHARGE PRESSURE IN ACCUMULATOR (for brea (If equipped) is needed for inspecting and charging with nitrogen gas. matsu distributor inspect and charge the accumulator. A special tool is needed for inspecting an d charging wi th nitrogen gas. Have your Ko matsu distribu tor inspect a nd charge the accumulator.