. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING 4 - 72 EVERY 2000 HOURS MAINTENANCE Carry out the periodic maintenance work o f every 100, 2 50, 500 and 100 0 hours of operati on at the same tim The parts and oil are a t high temperature immediately after th e engine is stopp ed, an d may cause s erious burns. Wait f or the temperature to go do wn before starting the operation If there is still pressur e remaining inside the case, the oil or pl ug may f ly out. L oosen the plug slowl y to release the pres sure. Please do not stand in front of the plug whe n you loosen the Refill capacity (each): 8.0 liters (2. Prepare a handle. 1.
Set the TOP mark at the top, with the TOP mark and plug (P perpendicular to t he ground surface. 2. Set a container un der plug (P) to catc h the oil. 3. Remove plugs (P) and (F) with the handle and drain t REMARK Check the O-rings in t with new ones. e. If necessary, replace 4. Tighten plug (P). e hole of plug (F). 5. Add oil through th 6. When oil begins to overflow from the p lug ( F) h ole, in stall plug (F). of plugs (P) and (F): ± 1 kgm, 50.6 ± 7.2 lbft) Tightening torque of plugs (P) and (F): 68.6 ± 9.8 Nm (7 ± 1 kgm, 50.6 ± 7.2 l REMARK There are two plugs (F ). Add oil through the one easier to f ill oil and through which no inter nal gears are to be seen .