Komatsu — ATTACHMENT REMOVAL AND INSTALLATION

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT Attachment Installation 6 - 17 1. Remove For buck et dismounting procedure, see "B UCKET REPLACEMENT AND INVERSION 2. Place th e attachment in a horizontal positio n, then install to the arm with pin (A) and the n pin (B) 3. Lower th e attachment to the ground and st op the engine. 4. Turn the starting switch to the ON position ( B), then set the lock lever to t he FRE E positio n (F). 5. After car rying ou t Step 4, operate each wor k equipmen t control lever an d attachment co ntrol pedal fully to the front, rear, left, and right 2 or 3 ti mes wit hin 15 seconds to release the internal pressure in the h ydraulic circuit. 6.

Set the l ock leve r to LOC K position