Explanation of components OPERATION Control levers, pedals Safety lock lever (for work equipment lever) 0. Before leaving the operator’s seat, set the safety lock lever securely to the LOCK position. If the safety lock lever is not at the LOCK position, and work equipment control lever is touched by mistake, it may lead to a serious accident. If the safety lock lever is not placed securely at the LOCK position, the work equipment control lever may move, and this may lead to a serious accident or personal injury. Check that the lever is in the LOCK position. When pulling up or pushing down the safety lock lever, be careful not to touch work equipment con- trol lever.
This lever (2) is a lock device for the work equipment control lever. Push the safety lock lever down to lock it. Free REMARK If the safety lock lever is at the LOCK position, the work equipment will not move even when the work equipment control lever is operated. Lock 9EA04443A Work equipment lever 0. Use this lever (3) to operate the lift arm and bucket. NOTICE Do not use the FLOAT position when lowering the bucket. Use the FLOAT position when leveling, see “Leveling oper- ations on page 3-78“. Position (a):
RAISE When the work equipment control lever is pulled further from the RAISE position, the lever is stopped in this position until the lift arm reaches the preset position of the kickout, and the lever is returned to the HOLD position. Position (b): HOLD The lift arm and bucket stop and remain in the same posi- tion. Position (c): LOWER Position (d): FLOAT The lift arm moves freely under external force. Raise AE41484B-A Lower Position (e): TILT When the work equipment control lever is pulled further from the TILT position, the lever is stopped in this position until the bucket reaches the preset position of the positioner, and the lever is returned to the HOLD position. Position (f):
DUMP Tilt Dump AE41485B-A 3-38 WARNING