Kubota — B Checking Radiator Hose and Clamp

PERIODIC SERVICE 90 B Replacing Hydraulic Oil Filter C Cleaning Magnetic Filter A To prevent serious damage to the hydraulic system, use only a KUBOTA genuine filter. B Checking Radiator Hose and Clamp Check to see if radiator hoses are properly fixed every 500 hours of operation. 1. If hose clamps are loose or water leaks, tighten bands securely. 2. Replace hoses and tighten hose clamps securely, if radiator hoses are swollen, hardened or cracked. Replace hoses and hose clamps every 4 years or earlier if checked and found that hoses are swollen, hardened or cracked. To avoid personal injury or death: A Be sure to stop the engine before changing the oil filter cartridge.

A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Remove the 2 oil filters. 2. Clean off metal filings with clean rags at the magnetic filters. 3. Put a film of clean transmission oil on rubber seal of new filters. 4. Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only. 5. After the new filter has been replaced, the transmission fluid level will decrease a little. Make sure that the transmission fluid does not leak through the seal, and check the fluid level. Top up if necessary.

(1) Radiator hoses (2) Hose clamps C Precaution at Overheating Take the following actions in the event the coolant temperature is nearly or more than the boiling point, what is called "Overheating" 1. Park the tractor in a safe place and keep the engine unloaded idling. 2. Don't stop the engine suddenly, but stop it after about 5 minutes of unloaded idling. 3. Keep yourself well away from the machine for further 10 minutes or while the steam blows out. 4. Check that there are no dangers such as burns. Get rid of the causes of overheating according to the manual, see "TROUBLESHOOTING" section, and then, start again the engine.

(1) Hydraulic Oil filter (1) Magnetic filter (Clean off metal filings)