89 PERIODIC SERVICE B Replacing Engine Oil Filter B Replacing Fuel Filter 1. Remove the fuel filter. 2. Put a film of clean fuel on rubber seal of new filter. 3. Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only. 4. Bleed the fuel system. (See "Bleeding Fuel System" in "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) To avoid personal injury or death: A Be sure to stop the engine before replacing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Remove the oil filter. 2. Put a film of clean engine oil on the rubber seal of the new filter. 3.
Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only. 4. After the new filter has been replaced, the engine oil normally decreases a little. Make sure that the engine oil does not leak through the seal and be sure to check the oil level on the dipstick. Then, replenish the engine oil up to the prescribed level. (1) Fuel filter (1) Engine oil filter A To prevent serious damage to the engine, use only a KUBOTA genuine filter.