Kubota — B Changing Engine Oil

PERIODIC SERVICE 88 EVERY 400 HOURS EVERY 500 HOURS B Cleaning Water Separator This job should not be done in the field, but in a clean place. 1. Close the fuel shutoff-valve. 2. Unscrew the retainer ring and remove the cup, and rinse the inside with kerosene. 3. Take out the element and dip it in the kerosene to rinse. 4. After cleaning, reassemble the water separator, keeping out dust and dirt. 5. Bleed the fuel system. (See "Bleeding Fuel System" in "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) B Changing Engine Oil To avoid personal injury or death: A Be sure to stop the engine before changing the oil. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1.

To drain the used oil, remove the drain plug at the bottom of the engine and drain the oil completely into the oil pan. 2. After draining reinstall the drain plug. 3. Fill with the new oil up to the upper notch on the dipstick. (See "LUBRICANTS, FUEL AND COOLANT" in "MAINTENANCE" section.) (1) Fuel cock (2) Retainer ring (3) Cup (A) "CLOSE" (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range (1) O ring (2) Element (3) Spring (4) Red float (5) Cup (6) Retainer ring (1) Drain plug Oil capacity with filter 10.7 L