Kubota — B Changing Transmission Fluid

PERIODIC SERVICE 92 EVERY 600 HOURS EVERY 1 000 HOURS B Adjusting Front Axle Pivot If the front axle pivot pin adjustment is not correct, front wheel vibration can occur causing vibration in the steering wheel. B Changing Transmission Fluid C Adjusting procedure Loosen the lock nut, screw-in the adjusting screw until seated, then tighten the screw with an additional 1/6 turn. Re-tighten the lock nut. To avoid personal injury or death: A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. To drain the used oil, remove the drain plug at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining reinstall the drain plug. 3.

Fill with the new KUBOTA SUPER UDT fluid up to the upper notch on the dipstick. (See "LUBRICANTS, FUEL AND COOLANT" in "MAINTENANCE" section.) 4. After running the engine for a few minutes, stop it and check the oil level again; add oil to prescribed level. (1) Adjusting screw (2) Lock nut B Adjusting King-pin Pivot Loosen the lock nut and tighten the adjusting screw with following torque: (1) Dipstick (2) Oil inlet (A) Oil level is acceptable within this range. (1) Adjusting screw (2) Lock nut B Changing Brake Oil Consult your local KUBOTA Dealer for this service. (1) Drain plug Oil capacity 60 L Adjusting screw 4.9 to 9.8 N-m, 0.5 to 1.0 kgf-m Lock nut 98.1 to 147 N-m, 10 to 15 kgf-m