OPERATING THE TRACTOR 24 A The main gear shift may be shifted between speeds on-the-go, but clutch must be depressed. C Creep speed should be used only when doing one of the following jobs: 1. Deep rotary-tilling and harrowing 2. Planting 3. Turf application C Shifting between and 1. Keep the engine running and the main gear shift lever at "neutral". Move the lever against the left-side face, and the speed changes each time between and . Be sure to use the clutch while shifting. 2. The pilot lamps (4) and (5) indicate that the shift is changed between and . 3. The buzzer sounds when the shifting is underway (with both the pilot lamps (4) and (5) off).
C Creep speed can not be used for any of the followings: 1. Pulling a trailer 2. Front-loader operation 3. Front-blade operation 4. Earth-moving 5. Entering and leaving a field 6. Loading onto and unloading from a truck B Range Gear Shift Lever The range gear shift can only be shifted when the tractor is completely stopped and the clutch is depressed. To avoid personal injury or death: A When you leave the tractor, be sure to apply the parking brake and stop the engine. A IN APPLYING THE BRAKES: A To avoid transmission damage, depress clutch pedal and stop the tractor before shifting between ranges. A The torque of the wheel axle is extremely high while creep speed is being used.
Be sure to step down on the clutch pedal completely before applying the brakes, or the torque will overcome the brakes. A When starting to operate the tractor, be sure to release the parking brakes. Misuse of the brakes may cause damage to the transmission and is therefore not acceptable to KUBOTA for coverage under the warranty. B Hydraulic-Shuttle Shift Lever Raise up and shift the shuttle shift lever forward to obtain forward speeds and shift back to obtain reverse speeds. This shifting does not require clutch operation. A The hydraulic-shuttle shift lever may be shifted while the tractor is moving slowly.
B Creep Lever (if equipped) Push down the creep lever at " " to obtain low speeds with range gear shift lever is selected "L" range. With the creep lever engaged (ON), the range gear shift lever cannot shift to "H". (The creep mode does not operate in the high-speed range.) This shifting requires clutch operation. A Press the clutch pedal completely down and stop the tractor's motion before shifting the creep lever. (1) Creep Lever (A) "LOW".....Creep ON (B) "HIGH".............Creep OFF