Kubota — B Draft Control

The standard tractor has 5 hydraulic control systems as shown below. Therefore, use the most appropriate system for the implement you are using. 3-POINT HITCH CONTROL SYSTEM B Position Control This will control the working depth of 3-point hitch mounted implement regardless of the amount of pull required. C 3-Point Hitch Control System 1. Position Control 2. Draft Control 3. Mixed Control 4. Float Control C Remote Hydraulic Control System 5. Combined Flow Control A Do not operate until the engine is warmed up. If operation is attempted when the engine is still cold, the hydraulic system may be damaged.

A If noises are heard when implement is lifting after the hydraulic control lever has been activated, the hydraulic mechanism is not adjusted properly. Unless corrected, the unit will be damaged. Contact your KUBOTA Dealer for adjustment. (1) Position control lever (2) Draft control lever (A) "FLOAT" (B) "DOWN " (C) "UP" B Draft Control This will control the pull of the 3-point implement. As the load on the 3-point hitch changes due to various soil conditions, the draft control system automatically responds to these changes by either raising or lowering the implement slightly to maintain a constant pull.

Place the position control lever in the lowest position and set the implement pull with the draft control lever. (1) Draft control lever (2) Position control lever (A) "UP" (B) "SENSITIVE" (C) "INSENSITIVE" (D) "FLOAT" HYDRAULIC UNIT 43 HYDRAULIC UNIT