HYDRAULIC UNIT 44 B Mixed Control In draft control, when draft decreases, the implement automatically lowers to increase draft. However, the implement sometimes lowers too much. To limit the degree, the implement can be lowered, set the position control lever at the lowest working depth desired for the implement. Lower the draft control lever to the point where the implement is at the desired depth. This stops the implement from going too deep and causing loss of traction and ground speed. B 3-point Hitch Lowering Speed To avoid personal injury or death: A Fast lowering speed may cause damage or injury. Lowering speed of implement should be adjusted to 2 or more seconds.
The lowering speed of the 3-point hitch can be controlled by adjusting the 3-point hitch lowering speed knob. (1) 3-point hitch lowering speed knob (A) "FAST" (B) "SLOW" (C) "LOCK" (1) Ground surface (2) Implement penetration limit (3) Light soil B Float Control Place both the draft control lever and the position control lever in the float position to make the lower links move freely along with the ground conditions.