Kubota — B Front Wheels (with 4 wheel drive)

50 TIRES WHEEL ADJUSTMENT To avoid personal injury or death: A Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper equipment. A Always maintain the correct tire pressure. Do not inflate tires above the recommended pressure shown in the operator's manual. To avoid personal injury or death: A When working on slopes or when working with trailer, set the wheel tread as wide as practical for maximum stability. A Support tractor securely on stands before removing a wheel. A Do not work under any hydraulically supported devices. They can settle, suddenly leak down, or be accidentally lowered.

If necessary to work under tractor or any machine elements for servicing or adjustment, securely support them with stands or suitable blocking beforehand. A Never operate tractor with a loose rim, wheel, or axle. A Do not use tires other than those approved by KUBOTA. A When optional different-diameter tires are fitted on the machine, the travel speed display mode must be changed. Otherwise the travel speed will not get correctly displayed. Such mode switching is also needed when the original tires are back on the machine.

(See "PTO RPM / TRAVEL SPEED MONITOR" in "OPERATING THE TRACTOR" section.) B Front Wheels (with 4 wheel drive) Front tread width can be adjusted as shown with the standard equipped tires. To change the tread width 1. Remove the wheel rim and disk mounting bolts. 2. Change the position of the rim and disk (right and left) to the desired position, and tighten the bolts. 3. Adjust the toe-in [2 to 8mm] See "Adjusting Toe-in" in "EVERY 200 HOURS" in "PERIODIC SERVICE" section. B Inflation Pressure Though the tire pressure is factory-set to the prescribed level, it naturally drops slowly in the course of time. Thus, check it everyday and inflate as necessary.

A Always attach wheels as shown in the drawing. A If not attached as illustrated, transmission parts may be damaged. A When re-fitting or adjusting a wheel, tighten the bolts to the following torques then recheck after driving the tractor 200m (200 yards) and thereafter according to service interval. (See "MAINTENANCE" section.) A Maintain the maximum pressure in front tires, if using a front loader or when equipped with a full load of front weights. B Dual Tires Dual tires are approved for turf tire applications.

(1) 260 to 304 N-m (26.5 to 31 kgf-m) TI RES, WHEELS AND BALLAST TIRES, WHEELS AND BALLAST Tire sizes Inflation Pressure Front 12.4R24 160 kPa (1.6 kgf/cm , 24 psi.) 13.6R24 160 kPa (1.6 kgf/cm , 24 psi.) 340 / 85R24 160 kPa (1.6 kgf/cm , 24 psi.) Rear 16.9R34 120 kPa (1.2 kgf/cm , 18 psi.) 18.4R34 120 kPa (1.2 kgf/cm , 18 psi.) 480 / 70R34 120 kPa (1.2 kgf/cm , 18 psi.)