77 PERIODIC SERVICE B Checking Parking Brake Pull the parking brake lever to apply the brakes. With the key switch at "ON" position, the parking brake indicator on the instrument panel lights up. To release the brakes, push in the button at the tip of the parking brake lever and tilt down the lever. EVERY 50 HOURS B Checking Engine Start System To avoid personal injury or death: A Do not allow anyone near the tractor while testing. A If the tractor does not pass the test, do not operate the tractor. A Make sure the ( ) lamp on the instrument panel goes off when parking brake lever is down. C Preparation before testing. 1. Place all control levers in the "NEUTRAL" position. 2.
Set the parking brake and stop the engine. C Test: Switch for the main gear shift lever. 1. Follow the instruction of "PARKING THE TRACTOR". (See "PARKING THE TRACTOR" in "SAFE OPERATION" section.) 2. Sit on the operator's seat. 3. Shift the main gear shift lever to the desired position. 4. Depress the clutch pedal fully. 5. Disengage the PTO clutch control switch or lever. 6. Turn the key to "START" position. 7. The engine must not crank. 8. If it cranks, consult your local KUBOTA Dealer for this service. (1) Parking brake lever (2) Release button (A) "PULL" (B) "RELEASE" C Test: Switch for the PTO clutch control switch or lever. 1. Follow the instruction of "PARKING THE TRACTOR".
(See "PARKING THE TRACTOR" in "SAFE OPERATION" section.) 2. Sit on the operator's seat. 3. Engage the PTO clutch control switch or lever. 4. Depress the clutch pedal fully. 5. Shift the main gear shift lever to the neutral position. 6. Turn the key to "START" position. 7. The engine must not crank. 8. If it cranks, consult your local KUBOTA Dealer for this service. B Checking Gauges, Meter and Easy Checker (TM) 1. Inspect the instrument panel for broken gauge(s), meter(s) and Easy Checker (TM). 2. Replace if broken. B Checking Head Light, Hazard Light etc. 1. Inspect the lights for broken bulbs and lenses. 2. Replace if broken. B Checking Seat Belt 1.
Always check condition of seat belt attaching hardware before operating tractor. 2. Replace if damaged. C Test: Checking Operator Presence Control (O.P.C.) System. 1. Follow the instruction of "PARKING THE TRACTOR". (See "PARKING THE TRACTOR" in "SAFE OPERATION" section.) 2. Make sure the PTO drive shaft is disconnected from the tractor. 3. Sit on the operator's seat. 4. Start the engine. 5. Engage the PTO clutch control switch or lever. The PTO should begin to rotate. Disengage the PTO clutch control switch or lever. 6. While lifting yourself from the seat, engage the PTO clutch control switch or lever. (1) The PTO should begin to rotate and a buzzer should sound.
(2) Disengage the PTO clutch control switch or lever. B Checking Movable Parts If any of the movable parts, such as levers and pedals, is not smoothly moved because of rust or sticky material, do not attempt to force it into motion. In the above case, remove the rust or the sticky material, and apply oil or grease on the relevant spot. Otherwise, the machine may get damaged.