Kubota — B Checking Wheel Bolt Torque

PERIODIC SERVICE 78 (3) If the buzzer does not sound, shut off the engine and consult your local KUBOTA Dealer for immediate servicing of the PTO OPC. 7. If the PTO OPC is operating properly, shut off the engine, and reconnect the implement drive shaft to the PTO. Restart the engine per the available instructions. B Checking Wheel Bolt Torque To avoid personal injury or death: A Never operate tractor with a loose rim, wheel, or axle. A Any time bolts and nuts are loosened, retighten to specified torque. A Check all bolts and nuts frequently and keep them tight. To avoid personal injury or death:

A Before checking the PTO OPC, make sure that the PTO drive shaft should be disconnected from the tractor. A If the buzzer does not sound during the PTO OPC check procedure, shut off engine and consult your local KUBOTA Dealer for immediate servicing of the PTO OPC. A The unit should not be operated until servicing is completed. Check wheel bolts and nuts regularly especially when new. If they are loose, tighten them as follows. N-m (kgf-m) (1) Main gear shift lever (2) Clutch pedal (3) PTO clutch control lever (1), (2), (3) (4) 260 to 303 (26.5 to 31.0) 343 to 401 (35.0 to 41.0)