COMPONENT OPERATION / Axle Principle of Differential Operational principle of the differential is explained comparing it to the racks and the pinion gear in the drawing. When load W is equally applied to racks A and B, if C is moved upward by the distance of H, racks A and B move by the same distance of H in unison with the pinion together. If moved by removing the load to rack B, the pinion rotates on rack A (with load applied) and moves rack B upward. At this time, the distance where rack B moves is longer than the distance where the pinion moves while rotating. Distance where rack B moves can be calculated by using the equation of H + H = 2H.
This principle is ap- plied to the differential. W W W C C H H H 2H Operation of Differential In Traveling Straight In case resistances applied to axle shafts (7, 8) connected by spline to differential side gears (2, 3) are the same, or in case the vehicle body is travel- ing straight on plane roads, differential pinion gears (1, 4) do not rotate. Differential pinion gears (1, 4) and side gears (2, 3) remain fixed by being mutually geared, and rotate with housing (6) connected with ring gear (9). In case all parts are rotating solidly like this, the dif- ferential function of the differential does not work, and gears (1, 2, 3, 4) play only the role of joints to connect axle shafts (7, 8).
Rack (A) Rack (B) Rack (B) Rack (A) T202-03-05-006 Pinion Pinion 9 10 1 8 3 7 2 6 4 T487-03-06-014 T3-10-4