DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika turbine casing turbiny: Date: 12.11.2013 Page 128 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ LP longitudinal pedestals / NT kozlíky podélný Drw. No. / č.v. Tp6071672 The weight without foundation bolts / Hmotnost bez základových šroubů =11550 kg · Unpack the pedestals, wash off the preservation from all contact surfaces and from surface of pedestal, check the conditions of the contact surfaces, it is necessary to repair all damages arrised during transport.

· Remove the foot-bridge from the opening in the top foundation slab in place for LP casing. · Carry out the same arrangement of the anchor bolts, their getting through pedestals and moving of the pedestals with foundation bolts on position as described above for the pedestals of bearing stands including the lower plates, washers and nuts (pos. 12 a 13, 15-16 a 19). Notices: Weight of anchor bolt is max. 13 kg. During putting of anchor bolts through the foundation slab be careful and avoid a damage of the thread’s ends. Attention: Never enter or put your limbs directly under the hung pedestal!!

· Carry out the assembly of lost shuttering for future embedding of pedestals into the grout compound. · Carry out the gradual tightening of the anchor · Vybalit kozlíky, smýt konzervaci ze všech dosedacích ploch a z povrchu kozlíku, zkontrolovat stav dosedacích ploch, veškeré závady vzniklé při dopravě je nutno opravit. · Odstraňte pochozí lávku z otvoru v horní základové desky v místě pro NT těleso. · Přípravu základových šroubů, jejich navlečení na kozlíky a zavezení kozlíků se šrouby na pozici proveďte stejně, jako je popsáno výše pro kozlíky ložiskových stojanů včetně montáže spodních desek, podložek a matic (poz.12 a 13, 15-16 a 19). Poznámky:

Max hmotnost základového šroubu je 21,5 kg. Při provlékání základových šroubů skrze základ dejte pozor, aby nedošlo k poškození závitových konců. Upozornění: Nikdy nevstupujte a nedávejte končetiny přímo pod zavěšený kozlík!! · Proveďte montáž ztraceného bednění pro budoucí zalití kozlíků do zálivkové hmoty. · Dotahujte postupně kotevní šrouby na cca 30% současně, však korigujte výšku a vyrovnání