Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika Assembly of bearing’s stands and their rough position setting: Montбž a zбkladnн vyrovnбnн ložiskovэch stojanů: · Bearings including the bearing’s shells are assembled inside of the bearing’s stands . · Remove the preservation from the contact surfaces of bearing stands and degrease them. Apply the antisizing compound Molycote G Rapid+ on the sides of grooves for parallel keys. · HP front and rear bearing stand: assemble the sliding foil (Metaloplast pos. 161, 162 ) on the bottom contact surface of the bearing stand.
If the foil is already assembled from production plant, check the condition of the foil surface only. The foil with the damaged surface has to be replaced. The foil has to be strenuous properly in the whole contact surface with the pedestal. · Put the stands on the pedestals, assemble the splice bars pos.21, 22 (HP front pedestal) without the screw’s tightening, attached the other bearing stands on the pedestals by means of bolts M30 (HP rear pedestal). · Ložiskovй stojany majн namontovбny ložiska včetně ložiskovэch pбnvн. · Odstraňte konzervaci z dosedacн ch ploch ložiskovэch stojanů a odmastěte je. Namažte boky drбžek pro pera protizбděrovou pastou Molykote G Rapid+.
· Přednн a zadnн VT ložiskovэ stojan: montujte kluznou folii (Metaloplast poz.161, 162 ) na spodnн plochu přednнho VT ložiskovйho stojanu. Pokud je folie již namontovбna z vэrobnнho zбvodu, kontrolujte pouze stav povrchu tйto fylie. Fylie s poškozenэm povrchem musн bэt vždy vym ěněna! Fylie musн bэt vypnuta v celй ploše styku s plochou kozlнku. · Položte stojany na kozlнky, montujte přнložky poz.21, 22 (přednн kozlнk) , bez dotaženн šroubů, přišroubujte ostatnн ložiskovй stojany ke kozlнkům – šrouby M 42 (z adnн VT kozlнk) . Date: 12.11.2013 Page 132 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ HP front bearing stand / Přední VT ložiskový stojan Drw. No. / č.v.
Tp6076998 The weight including bearings / Hmotnost včetně ložisek = 4522 kg The weight including bearings and pedestal/ Hmotnost včetně ložisek a kozlíku= 4522 kg HP rear bearing stand / Zadní VT ložiskový stojan Drw. No. / č.v. Tp6072597 The weight including bearings / Hmotnost včetně ložisek = 4700kg The weight including bearings and pedestal/ Hmotnost včetně ložisek a kozlíku = 4700 kg