DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika · All spacers and pads which determinate the mutual position of the outer casing and the inner parts are grinded completely up to the right thickness and are attached to the inner parts or put free inside wooden box. · Leave the inner parts in closed form and measure the bore ovality in accessible places and compare the readings with the record before transport (Turbine Pasport book). Remove partly the preservation from inner surfaces if required due the measuring.

· Dismantle the mentioned inner parts up to the parting planes, remove the preservation from the outer surfaces and apply the anti-sizing compound Molycote G Rapid+. Degrease the parting plane. There is not necessary to remove the preservation from inner surfaces if it does not complicate the measuring · Before start of assembly degrease the outer contact surfaces of inner parts and aply the anti-size compound Molykote G Rapid + onto friction surface. · Put the bottom inner parts into the bottom outer casing (inner casings, carriers, bottom of diaphragms, glad bodies) · Perform the level measurement:

slopes of · Veškerй mezikusy a podložky určujнcн vzбjemnou polohu spodku vnějšнho tělesa a vnitřnнch dнlů jsou již hotově přebroušeny na potřebnou mнru a namontovбny na vnitřnн dнly nebo volně uloženy v přepravnн bedně. · Proměřte ovalitu vэvrtu zavřenэch vnitřnнch dнlů na přнstupnэch mнstech a porovnejte s hodnotami před transportem (uvedeno v Pasportu turbiny). Za ъčelem měřenн odstraňte lokбlně konzervaci z vnitřnнch ploch. · Demontujte uvedenй vnitřnн dнly do dělнсн roviny, vnějšн dosedacн plochy zbavte konzervace a naneste pastu Molykote G Rapid+. Dělнсн roviny odmastěte. Konzervaci z vnitřnнch ploch nenн třeba odstraňovat, pokud nebude komplikovat měřenн.

· Před zahбjenнm montбže vnitřnнch dнlů odmastit vnějšн dosedacн plochy rozvбděcнch kol a drбžky ve vnitřnнm tělese a nanйst pastu Molykote G Rapid + na všechny třecн plochy. · Vložte spodky vnitřnнch dнlů do vnějšнho tělesa (vnitrnн tělesa, nosiče, spodky RK, tělesa ucpбvek). · Proveďte měřenн vodovбhou: nбklony Date: 12.11.2013 Page 172 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ