Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika surfaces of the casing’s feet. · Hang the HP casing on a crane or on the lift of a manoeuvre equipment, lift it up from the transporting stand and move it onto arranged bearing stands (on supporting wedges Tp318707 ). konzervace. · Zavěšte VT těleso na jeřбb nebo zdvih manйvrovacнho zařнzenн, zvedněte je z dopravnнho stojanu a přemнstěte j e na připravenй ložiskovй stojany (na stavěсн klнny Tp318707 ). Attention:
Apply always the way of hanging and sling means in accordance with drawing Tp6079138 (Ropes for HP part transport) for hanging of HP casing in closed form on any crane together with transporting stand as well as without the stand. Upozorněnн: Pro zavěšenн VT tělesa v zavřenйm stavu na jakэkoli jeřбb se stojanem i bez stojanu použнvejte vždy způsob zavěšenн a vбzacн prostředky podle vэkresu Tp6079138 (Lana pro dopravu VT dнlu) · Put the HP casing in closed form on the adjustable wedges. Assemble the feathers pos.31, screws pos.32 (M64x4), washers pos.101, nuts pos.91 and prepare the pins pos.1132 all in drw.no. Tp6076998 of the front HP bearing stand.
Assemble bed sheets pos.48, the feathers pos.47, screws pos.49 (M64x4), washers’ pos.50, nuts pos.51 and prepare the pins pos. 52 all in drw. no. Tp6072995 of the rear HP bearing stand. The feathers are re-grinded to the final shape and dimensions from DSPW workshop. · Položte VT těleso v zavřenйm stavu na stavěсн klнny. Namontovat pera poz. 31 , šrouby poz. 32 (M64x4), podložky poz. 101, matice poz.91 a připravte kolнky poz. 113 vše na vэkrese přednнho VT ložiskovйho stojanu Tp6076998. Namontujte podloženй plechy poz.48, pera poz.47, šrouby poz.49 (M64x4), podložky poz.50, matice poz.51 a připravte kolнky poz.52 vše na vэkrese zadnнho VT ložiskovйho stojanu Tp6072995 .
Pera jsou nabroušenб na finбlnн tvar a rozměr z dнlen DSPW Date: 12.11.2013 Page 178 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ