Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika · Prepare the adjustable supporting wedges Tp318707 and put them on the bearing stands. · Připravte stavěсн klнny Tp318707 a uložte je na ložiskovй stojany. · Take out the bottom part of the bearing shells of radial bearings and the bottom stones of thrust bearing. · Prepare the parallel feathers and screws for connecting of casing to the bearing stands. · Shift the IP and LP turbine rotor towards the generator in range of axial clearance in IP and LP steam flow path.
· Dismantle the nuts poz.15 of transporting stand (drawing Tp6077357 ), remove the covers of journals and wash off the preservation from the accessible contact Place for adjustable supporting wedges Mнsto pro stavěсн klнny · Vyjměte spodky pбnvн radiбlnнch ložisek a kameny spodku axiбlnнho ložiska. · Připravte pera a šrouby pro připojenн tělesa k ložiskovэm stojanům. · Proveďte odsunutн ST a NT rotoru turbiny směrem ke generбtoru, v rбmci axiбlnн vůle v ST a NT parnн průtočnй čбsti. · Demontujte matice poz.15 přepravnнho stojanu tělesa (vэkres Tp6077357 ), demontujte kryty čepů rotoru a očistěte přнstupnй dosedacн plochy patek tělesa od Date: 12.11.2013 Page 177 / 278 Prepared:
O.Baroch Last Revision: Approved: P.Lešetickэ