DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika · Assemble the bottom part of bearing shell, disassemble the bottom half of locking plate of the HP rotor and lower the journals into the bearing (lowering carry out only by means of the delivered lifting yokes) · Disassemble the yoke and carry out the same activities on the second journal. · Namontujte spodnн pбnev ložiska, demontujte spodnн polovinu aretace VT rotoru a spusťte čep do ložiska (spouštěnн provбdějte vэhradně pomocн dodanэch zvedacнch třmenů). · Demontujte třmen a stejnou činnost proveďte na druhйm ložiskovйm čepu. Attention:

The rotor must not be put in the lifting yokes on the both ends at the same time. · Continuously check the mutual position of the HP rotor against the stator ( must not be changed to the both sides radially more then 0,3 mm and axially more then 2,0 mm ). Attention: The values written above proceed from the drawings values. Check them with the real clearances which are always recorded in Turbine Dozier book. · Measure the alignment of the rotors catenary in couplings and correct the deviation arised Pozor: Rotor nesmн bэt uložen ve zvedacнm třmenu současnй na obou koncнch!

· Průběžně kontrolujte vzбjemnou polohu VT rotoru vůči statoru ( nesmн se radiбlně měnit vнc jak o 0,3 mm a axiбlně o 2, 0 mm na obě strany ). Upozorněnн: Uvedenй hodnoty vychбzн z vэkresovэch hodnot vůlн. Kontrolujte je se skutečnэmi vůlemi, kterй jsou vždy zaznamenбny v pasportu turbiny!! · Proveďte měřenн vyrovnбnн rotorovй soustavy ve spojkбch a korigujte odchylky vzniklй Date: 12.11.2013 Page 181 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ