DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika Sensors for monitoring of the vibration and displacements: Attach of the holders, attach the sensors and set their distance from surface of the measured components, install and seal the bushings according to drawing Tp6079324 . For the sealing of outlets bushings with wall of bearing stands use the sealing rings and also the suitable compound with sufficient temperature resistance. The sealing compound must not react with the lubrication oil or to influe his properties as deemulsification factor (use for instance TL cement Novato 350).

Connect the armoured hoses by means of the hose connectors PG11 and drill the hose clamps. · Mark the sensors by the labels · Connecting of all sensors into the system of measuring of displacements and vibration will be done by I&C electrician. Speed sensors Install the holders, sensors and bushings according to drawing Tp6077217 . Assemble the bushings and seal it with suitable sealing paste (Novato TL350) except the sealing ring. Sealing paste must not react with the lubrication oil. The right clearance setting between the sensor and geared rim is not mentioned on drawing set the exact values X according to supplier Čidla pro měřenн chvěnн a posuvů:

Upevně te držбк y, u pevněte čidla a nastavte jejich vzdбlenosti od povrchu měřenйho dнlu , montujte a zatěsně te průchodk y dle vэkresu Tp6079324 . Pro zatěsněnн průchodek vэvodů skrze stěny ložiskovэch stojanů použijte kromě těsnнcнch kroužků takй vhodnэ tmel s dostatečnou teplotnн odolnostн. Tmel nesmн reagovat s mazacнm olejem a ovlivnit jeho vlastnosti – deemulgačnн čнslo (např. TL tmel Novoto 350). Ochrannй kovovй hadice připojte pomocн hadicovэch koncovek PG11 a přivrtejte přнchytky hadic. · Označte čidla · Zapojenн všech čidel do systйmu měřenн posuvů a chvěnн provede elektrikбř SKŘ. Čidla otбček Držбку, čidla a průchodky montujte dle vэkresu Tp6077217 .

Průchodky montujte a zatěsněte je kromě těsnнcнho kroužku takй vhodnou těsnнcн pastou ( tmel Novato TL350), těsnнcн pasta nesmн ovlivnit vlastnosti mazacнho oleje. Hodnota nastavenн vůle čidla od povrchu ozubenйho věnce nenн na vэkrese uvedena – hodnotu X nastavte dle průvodnн dokumentace vэrobce dodanэch čidel (Woodward a Philips). Date: 12.11.2013 Page 199 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ