Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika · Draw the position of supporting plates of the stands of IPSC bodies onto the consoles and steel plates embedded into the top concrete slab of foundation stool. Determine this position with respect to the position of steam inlets into IP turbine casing and to the longitudinal axis of turbine casing which are drawn in drawing no. Tp6072207 . · Measure up the altitude of these supporting areas. Difference of these altitude on foundation of each valvesґbody has to be Ј 5 mm .
If this tolerance is not kept, carry out the modification of the seating of supporting elements of valve bodies in accordance with the below written instructions. While it is true, that during the modification it is permited to put between the stand and plate a steel-sheet insert with max. thickness 10mm. · Narэsujte polohu podpěrnэch desek podpěr stojбnků těles S T RZR na konzoly a ocelovй desky zalitй do hornн betonovй desky zбkladovй stolice. Při určenн tйto polohy vychбzejte z polohy osy vstupu pбry do ST tělesa turbiny a podйlnй osy S T tělesa turbiny zakreslenй na vэkrese Tp6072207. · Proměřte vэškovou polohu těchto opěrnэch ploch optickou nivelacн.
Vэškovэ rozdнl opěrnэch ploch na zбkladu každйho tělesa ventilu musн bэt Ј 5 mm . Pokud tato tolerance nenн splněna, proveďte ъpravu v uloženн opěrnэch prvků těles ventilů dle instrukcн nнže. Přitom platн, že je při opravě povoleno vložit mezi desku a beton ocelovou plechovou vložku o maximбlnн tloušťce 10mm . Do not carry out the welding or tack- welding of holder to the foundation!! Stojбnek zatнm nepřivařujte ani nestehujte k zбkladu !! Date: 12.11.2013 Page 203 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ