Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika assembly of the in-built insert as the protection of the seat of cone of valves spindle) or without inlet to the turbine valve body after welding of blind-bottom to pipeline in front of the valve (closing weld is done after the pressure test after cutting the blind-bottom off and it is checked only by X-ray and by hardness measurement).
Before the steam entrance into turbine the tightness test of whole vacuum space is done during the putting of LP by-pass station into operation (monitoring of value of vacuum after the vacuum pumps ґ starting up and after congestion of turbine glands by steam and after the interruption of the vakuum pumpsґ running ). pro ochranu sedla kuželky vřetena ventilu) nebo bez vstupu vody do tělesa ventilu turbiny po přivařenн zбslepky parovodu před ventilem (zбvěrnэ svar je proveden až po tlakovй zkoušce - po odřнznutн zбslepovacнho dna a je kontrolovбn pouze prozбřenнm a z měřenнm tvrdosti).
Před vpuštěnнm pбry do turbiny se provбdн v rбmci uvбděnн NT parnнch přepouštěcнch stanic do provozu kontrola těsnosti vakuovйho prostoru (sledovбnн hodnoty vakua po spuštěnн vэvěv po zahlcenн ucpбvek turbiny parou a po přerušenн chodu vэvěv ). Date: 12.11.2013 Page 278 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ 2.16 Instruction for doing of the individual tests/ Pokyny k provedení individuálních zkoušek In scope of the individual tests the test of turning gear is carried out on turbine as well as the tests of the steam control oriffices and turbine valves. The other individual tests are carried out on turbine accessories ie.
The lubricating & jacking oil system, HP hydraulic, gland & vent steam system and drainage system – it is the individual tests on valves and their drives, aggregates of HP hydraulic, pumps and their electrical motors. V rámci individuálních zkoušek se provede na turbině zkouška chodu natáčela turbiny, zkoušky regulačních clon a armatur turbiny. Ostatní individuální zkoušky jsou prováděny na příslušenství turbiny tj. systém mazacího & zvedacího oleje, VT hydraulika, systém ucpávkové & komínkové páry a systém odvodnění – jedná se o IZ na armaturách a jejich pohonech, agregátech VT hydrauliky, čerpadlech a jejich elektromotorech.