Care and Maintenance 7 7.9 Immobilization 7.9.1 Preservation (temporary immobilization ) 7.9.2 During immobilization Machine damage When the machine is out of use for 6 months, after this time all assemblies must be brought to operating temperature and maneuvered for approx. 15 minutes. due to damage from storage (e.g. corrosion damage) during shutdown periods over three months. Perform the preservation measures. Beforehand, the anti-corrosion coat must be removed from the piston rods, and the openings of the air filter system and the exhaust pipe freed. Preservation measures: We recommend keeping the machine in a dry, dust-free room during the storage period.
After the maneuvering cycle, preserve the machine once more as previously described. Thoroughly clean the inside and outside of the machine, including the engine. 7.9.3 After immobilization Lubricate the machine according to the lubrication plan. Before putting the machine into operation once more, the following measures must be carried out: Check the oil levels of all assemblies such as axles, transmission(s), etc. and top up if necessary. Anti-corrosion coat must be cleaned from the piston rods. Check the hydraulic oil level and top up if necessary. Seal off the air intake opening of the air filter and the exhaust pipe opening. Repair any paint damage.
Remove the air filter insert, check its condition and replace if necessary. Fill the diesel tank completely, to prevent corrosion of the tank walls. Clean the machine with a neutral detergent. Check the antifreeze level in the coolant and adjust if necessary. Check and, where required, re-charge and re- install the battery. Perform all preservation measures specified in the Diesel Engine Operating Instructions. Carry out all measures for putting the diesel engine back into operation listed in the Engine Operating Manual. Check the tire pressure according to the prescribed value and protect the tires from direct sunlight.
If the machine has been out of use for more than 6 months, the oil in the assemblies such as axles, transmission(s), etc. must be changed. Treat bare piston rods with a commercially available anti-corrosion agent. If hydraulic oil filters such as suction and return filters as well as breathers have been out of use for more than 6 months, they must be replaced. Remove and clean the battery and keep it according to regulations in a dry - in winter, frost- proof - room. Coat connections with a little pole grease. Lubricate the machine according to the lubrication plan. Seal off the air intake opening of the air filter system and the exhaust pipe opening.
103/112 TL160 Operating Manual 12.9.08 Version 1.0