Terex TL160 — 7.8.20 Windshield washer system

Care and Maintenance 7 7.8.18 Cabin ventilation dust filter The air intake for the heater and fresh air supply of the cabin features a dust filter, optionally a charcoal/ pollen filter. 7.8.19 Removing the dust filter for cabin ventilation Remove the ventilation louver (80/1). Remove the angle bracket (80/2). Remove the dust filter (80/3). Clean the filter or replace it. 7.8.19.1 Cleaning the dust filter Attention Never wash or brush out the filter. Knock the filter with the intake side (side covered by expanded metal) several times on a flat and hard surface. Using dry compressed air (max. 5 bar), blow against the direction of flow. Check the filter for damage to the paper bellows and seal.

Attention Never continue to use damaged dust filters! Fig. 80 Removing the dust filter for cabin ventilation 7.8.19.2 Installation Insert new or cleaned dust filter until the stop. 1 Attention Observe the mounting position of the dust filter; the air flow arrows must point towards the cabin. Re-attach the dust filter with the angle bracket. Re-install the ventilation louver. 7.8.20 Windshield washer system Top up the windshield washer tanks (81/1) as required. Add antifreeze when temperatures are around or below freezing. Fig. 81 Topping up the windshield washer tank 102/112 TL160 Operating Manual 12.9.08 Version 1.0