Trouble-shooting 8 Tab. 31 Table of faults 107/112 TL160 Operating Manual 12.9.08 Version 1.0 Possible cause Remedy Transmission works in one direction only Switch for travel direction damaged Repair or replace if necessary Solenoid valve gets stuck or is damaged Repair or replace if necessary Power supply towards switch for travel direction or solenoid valve interrupted Check and repair (incl. ground connection) Pilot pressure too low on one side Nozzles clogged, check, repair High-pressure relief valve is faulty or incorrectly adjusted Swap valves around. If machine now travels in the other direction, examine valve, clean and replace if necessary.
Transmission works in neither direction Too little hydraulic oil in tank Top up oil to mark on dipstick Mechanical connection to diesel engine faulty Check, repair Charge pump damaged, no charge pressure Remove pump and examine, install new pump if necessary Switch for travel direction damaged Repair or replace if necessary Solenoid valve for travel direction damaged Repair or replace if necessary Suction filter clogged Replace filter Suction line between tank and pump kinked Check and eliminate kink Power supply towards switch for travel direction and solenoid valve interrupted Remedy cause of interruption Internal damage to travel pump or travel motor Replace units completely Mechanical connection between travel motor and axle interrupted Check, repair Loader installation is not working Oil supply to pump interrupted Check suction line and repair if required Main pressure relief valve damaged Check and replace if necessary Hydraulic pump damaged Check, repair or replace Hydraulic pump drive mechanically interrupted Check and repair