Terex TL160 — 7.8.2 Engine oil

Care and Maintenance 7 7.8 Inspection and maintenance work 7.8.1 Checks using the display P Attention All checks must be carried out with the machine standing on level ground and cooled down. + - 1/2 0 4/4 The levels of engine oil, hydraulic oil and coolant can be read on the check display. Attention With the diesel engine running, the level indicator is without function! Checking Switch on the ignition. The symbols “engine oil level” (38/71), “hydraulic oil level” (38/72) and “coolant level” (38/73) light up for approx. 3 sec on the display. 71 72 73 If the level is insufficient, the relevant level indicator lamp continues to light up. Fig.

38 Checks using the display If required, top up the missing fluid. 7.8.2 Engine oil 7.8.2.1 Checking the engine oil level The oil level must be checked daily before start-up with the machine standing on level ground. Observe the level indicator on the display of the instrument panel. Insert the oil dipstick (39/1) until the stop. The notches on the dipstick indicate the minimum and maximum oil levels. Top up engine oil if necessary. Open the filler neck (39/2) and add oil using a clean container. Close the filler neck again. Machine damage due to excess oil. Fig. 39 Checking the engine oil level Observe the permissible filling level of the engine oil pan and avoid overfilling.

Excess oil may enter the crankcase breather and lead to engine-speed control faults. 76/112 TL160 Operating Manual 12.9.08 Version 1.0