Care and Maintenance 7 7.8.2.2 Changing the engine oil Attention Collect the waste oil in a suitable container and dispose of in compliance with regulations. Run the engine until it reaches operating temperature, engine oil temperature approx. 80 °C. Park the machine on a level surface. Stop the engine. Remove the cover from the bottom rear-end. Place suitable drip pans under the opening. Danger of scalding due to hot oil getting into contact with skin or eyes. Wear appropriate protective clothing/safety goggles. Screw the oil drain hose onto the oil-change valve (40/1). Drain oil. Remove the oil drain hose and screw the protective cap onto the valve (40/1).
Close the service opening with the cover. Replace the engine oil filter (40/2) ( О 7.8.3, 78). Top up engine oil to the "MAX” mark on the oil dipstick (40/3) using the filling hole (40/4). 3 4 Machine damage due to excess oil. Observe the permissible filling level of the engine oil pan and avoid overfilling. Excess oil may enter the crankcase breather and lead to engine-speed control faults. Fig. 40 Changing the engine oil L864-733 Start the engine and run at low idle speed for approx. 2 min. Stop the engine. Check the oil level and top up oil if required. 77/112 TL160 Operating Manual 12.9.08 Version 1.0