Care and Maintenance 7 7.8.3 Changing the engine oil filter The engine oil filter must be replaced every time the engine oil is changed. Place oil drip pan below the engine oil filter. Clean the outside of the engine oil filter. Unscrew the filter cartridge (41/1) using a commercially available tool and check that the fastening stud is firmly secured in the filter head. Dispose of the filter cartridge according to regulations. Check the filter head condition and clean. Fill the new filter with oil, wet the sealing ring with oil and tighten firmly by hand. After a test run, check the tightness of the engine oil filter cartridge. Fig.
41 Changing the engine oil filter 7.8.4 Cooling system - combined hydraulic oil- water cooler 7.8.4.1 Checking coolant level / topping up coolant The coolant level is monitored automatically. If the coolant level is insufficient, the coolant level indicator appears on the display as soon as the ignition is switched on. (42/73). Top up coolant if the coolant level is insufficient with the machine standing on level ground. Danger of scalding due to hot coolant getting into contact with skin or eyes. Only open the cooler cap after the engine has cooled down. Remove the cover (43/1) and top up coolant if required. With the engine cooled down, the compensation tank should be half full. Fig.
42 (42/Coolant level indicator Attention Refill with a mixture of 50 % water and 50 % antifreeze. 7.8.4.2 Checking the level of antifreeze Before the beginning of the cold season, check the level of antifreeze. At the factory, the antifreeze protection is set to approx. - 25 °C. If temperatures are lower, the level of antifreeze must be adjusted accordingly. Fig. 43 Combined cooler 78/112 TL160 Operating Manual 12.9.08 Version 1.0