Terex TL160 — 7.8.4 Cooling system - combined hydraulic oil- water cooler

Care and Maintenance 7 7.8.4.3 Changing coolant Danger of scalding due to hot coolant getting into contact with skin or eyes. Only open the cooler cap after the engine has cooled down. Park the machine on level ground. Switch off the engine and allow the cooling system to cool down . Remove the cooler cap (44/1). Remove the rear maintenance cover. Fig. 44 Combined cooler Unscrew the water-drain plug (45/1) on the drain hose (45/2) and drain coolant. Collect the coolant and dispose of according to regulations. If necessary, flush the cooling system with clean water. Close the drain hose using the drain plug. Re-install the rear maintenance cover.

Fill the cooling system with coolant ( О 3.9, 29) and close the cap. Fig. 45 Changing coolant Start the engine and bring to operating temperature; turn off the engine and allow to cool. Danger of scalding due to hot coolant getting into contact with skin or eyes. Only open the cooler cap after the engine has cooled down. Remove the cap (44/1) and top up coolant if required. With the engine cooled down, the compensation tank should be half full. 79/112 TL160 Operating Manual 12.9.08 Version 1.0