Terex TL160 — 7.8.4 Cooling system - combined hydraulic oil- water cooler

Care and Maintenance 7 7.8.4.4 Cleaning cooling fins in case of extreme exposure to dust 2 The combined cooler features a fan (46/1) with hydrostatic drive (46/2). Due to the automatic reverse of the running direction of the fan, the cooler fins are automatically cleaned at regular intervals. If there is increased exposure to dust, the cooler fins are subject to premature contamination. 1 Machine damage due to strong accumulation of dust. Fig. 46 Engine cooler fan Clean the cooler fins in due time to prevent overheating of the engine and/or the hydraulic oil. Press the engine cooler fan changeover switch (47/39). The fan briefly runs in the opposite direction. The cooling fins are cleaned.

7.8.4.5 Cleaning cooling fins in case of strong exposure to dust Fig. 47 Engine cooler fan changeover switch Machine damage due to strongly contaminated cooler. Clean the cooler fins in due time to prevent overheating of the engine and/or the hydraulic oil. If necessary, e.g. in case of an oiled combined cooler, clean with cleaning agents or a steam jet device. After cleaning, run the engine until it reaches operating temperature to allow the combined cooler to dry. Attention Collect the detergent and waste water in a suitable container and dispose of according to regulations! Ensure that no substances hazardous to water reach the sewerage or water systems.

80/112 TL160 Operating Manual 12.9.08 Version 1.0